Speed ​​limiter (3.7 to 12v) - Electric scooters

Technical specifications :
-Speed ​​limiter with a frequency of 433MHZ -Prpar
for supply voltages of (3.7 12v), it can connect the 5v power supply of the hall sensors or 3.3v of the Bluetooth module, voltages available in most controllers so that it does not need a voltage regulator for its installation.
- Maximum charging current: 1A (700mA maximum current is recommended in continuous work)
- Standby current: 4ma
- Size of the card without case: 34 x 14 x 7.4mm
-Case size: 39.5 x 20 x 10.5mm

Connection modes available:

-Port normally open (NO)
-Common port (COM)
-Normally Closed Port (NC)
Operating modes: push button, switch and signal with delay. Detailed configuration below.

Description

The relay with the command can be configured in the following modes:

Push button mode: The relay remains active when the command is pressed, inactive when it is released.

Press the learn button 1 time. Then press the button on the remote control, the indicator. If the LED on the card flashes once and turns off, it has been configured correctly.

Switch mode: The relay is activated when the button is pressed once and deactivated when it is pressed again.

Press the learn button twice. Then press the button on the remote control, the LED light flashes 2 times and turns off, which means learning successfully.

Timed disconnection/connection mode:

- Delay time (5s): Press the learning button 3 times. Then press the button of transmitter A, the Led light flashes 3 times, then press the button of transmitter B, the Led light goes out, which means learning successful.

- Delay time (10S): Press the learning button 4 times. Then press the button on the transmitter, the LED indicator flashes 4 times and turns off, which means learning successfully.

- Shutdown time (15S): press the learning button 5 times. Then press the button on the transmitter, the LED indicator flashes 5 times and turns off, which means learning successfully.

- Delay time (20S): Press the learning button 6 times. Then press the button on the transmitter, the LED indicator flashes 6 times and turns off, which means learning successfully.

Reset: press the learning button 8 times until the LED indicator on the receiver flashes 8 times, which means the setting has been cleared (before changing the working mode, you must first clear the coded)