Application,

Folding scooter controller replacement, wheel 4"5"5.5"6.5"8"8.5", power 350w and below
carbon fiber scooter controller kit,
Controller
Controller installation size
86*46*38mm

Application,

Technical data
Data Parameter Enter the setting page by pressing the up and down key simultaneously for 2 seconds.
5 speed e-slide controller
  • P1: Backlight 1.2.3
  • P2: speed unit, 1 mp/H, 0 km/H
  • P3, 0 no standby 1-60 times before standby
  • P4. zero start, 1 is a non-zero start (the wheel needs to be pushed before accelerating and then the wheel will run) 0 is a zero start. (The wheel will spin directly when you accelerate)
  • P5, cruise, 1 cruise, 0 is no
  • P6, None
  • P7, 0 at full, other speed adjustment values ​​1-100%
  • P8, Wheel Diameter, 5.5
other modeled
P1: speed unit, 1 mp/H, 0 km/H
P2: cruise, 1 cruise, 0 is no
P3, zero start, 1 is non-zero start (the wheel needs to push wen you do while accelerating and then the wheel will run) 0 is zero start. (The wheel will spin directly when you accelerate)
P4. Wheel diameter, 5.5" it was stuck and could not be changed

P5, voltage 24v or 36v

P6, None
P7, None
P8, data cleared. 1 is clear 0 is no.


Technical data
A) P0, lack of voltage (battery voltage lower than this will not work)
B) P1, impeller diameter, (5.5)
C) P2, motor pole pairs, (usually for 5.5" is 20)
D) P3, it is speed signal choice (speed from hall sensor or LCD meter)
E) P4 is km or Mile. 0 is km, 1 is Miles
F) P5. 0 is zero start, 1 is not.
G) choice of cruise P6. (it is related to scooter model). 1 is yes. 0 is no.
H) P7. Soft start choice (it is related to scooter model) 0 is soft start. 1 is hard
I) P8,ODO to zero. Erase record mileage
---------------
000100020003
00040005
lcd-display (1)
Thumb Brake Thumb LCD Display
LCDs (2)
The unit kit
LCD (5)
A. Noise test, not working properly. The motor moves, jerks, vibrates but does not work.
This means the phase wire from the controller to the motor does not match!
First we need to configure the phase. Please test these 6 methods one by one and choose the best one smoothly.
Y, yellow wire
G, green wire
B, blue wire
center
B. Motor runs fine but was in reverse. Please change the wire connection as below until it works well.
center
For any questions, do not hesitate to contact us.

Newsletter

A short sentence describing what someone will receive by subscribing